hvac strut gripper for downward facing strut

zf-25-1213-kfb strut gripper for hvac cable suspension

Strut Gripper downward facing strut

Name: Strut Gripper downward facing strut
SKU: 42951

$1.00

ZF-25-1213-KFB
for use with 3/32”

ZF-30-STRUT-KFB
for use with 1/8” cable

Cable Diameter

Clear

SKU: N/A Category: HVAC

Add to Quote

The SMACNA Testing and Research Institute verified the Strut Gripper from Griplock Systems is an acceptable alternative to the duct hanger systems prescribed in the SMACNA HVAC Duct Construction Standards (HVAC-DCS), 4th edition, Chapter 5, Tables 5-1, 5-1M and 5-2. The strut gripper comes in two sizes to be used with galvanized cable with diameters from 3/32” – 1/8”, providing working load limits ranging from 100 pounds up to 200 pounds per suspension point. (note: one piece of strut requires a gripper on each side – doubling the WLL shown below for that section). The strut gripper hanging system is easier and faster to install than traditional HVAC hangers and straps, saving time and labor costs. This strut gripper is designed to be used with downward facing strut for secure support and allows the installer to make tool-free height adjustments and level ductwork quickly. The galvanized cable can be purchased in bulk spools or cut to length and supplied with a variety of end fittings to secure to structure.

For attaching to downward facing strut
Bottom cable exit
Ability to connect multiple grippers to multiple ducts with a single cable

Note: Working Load Limits are for each suspension point. A minimum of 2 points are needed (one for each side of the duct)

Additional information

Cable Diameter	3/32", 1/8"
Working Load Limit (WLL)	100 lbs., 200 lbs.

ZF-25-1213-KFB-S rA

ZF-30-STRUT-KFB

Return Policy

NO RETURNED GOOD SHALL BE ACCEPTED WITHOUT A RETURN MERCHANDISE AUTHORIZATION (RMA) ISSUED BY GRIPLOCK.

Griplock®, at its sole discretion, may accept returns under the following conditions:
Goods are Stock items.
Goods are returned at Buyer’s expense.
Goods are returned within 15 days from the issuance of an RMA.
Goods were purchased within the 30 days previous to the issuance of an RMA.
Goods are deemed re-saleable.
Goods are unused and undamaged.

Upon inspection and acceptance of goods by Griplock®’s Quality Control Department, a Credit Memo will be issued. Credit Memos shall then be applied to future orders only, not to existing invoices. Credit must be redeemed within 1 year from the date of the Credit Memo. There will be no cash refunds. All returned goods are subject to a re-stocking charge. The schedule of re-stocking charges is as follows:
Bulk-shipped stock items – 20%
Bulk-shipped assemblies of stock items – 30%
Packaged sets of stock items – 35%
Proprietary or custom parts – 40%
Kits that include power cord – 50%

Strut Gripper downward facing strut

Related

Additional information

Return Policy